TOP 10 best pumps for watering the garden: which one to buy, reviews

In the hot season, when most plants, shrubs and trees bear fruit, watering is imperative. Natural irrigation is often insufficient for the normal development of fruits and flora growth on the site. To ensure that water is pumped into a hose or watering facility, a water pump is needed. They are huge, pump from 30 meter wells and more, and there are also compact models for pumping from a tank. There are many varieties of pumps, so the tasks of this article are: to understand them, study the features of the best devices and delve into the intricacies of choice.

Types of pumps

By type, a pump for watering a garden can be:

• Barrel for pumping liquid from a container. It is good for pumping water from large barrels and tanks. Belongs to the compact class weighing about 4 kg. It is easy to carry around the site and use to treat plants with chemicals. The model is fixed on the edge of the container and reaches its bottom with a tube.
• Surface pump. Suitable for pumping liquid from a well (up to 10 m deep), a small reservoir, a pool. Its main problem is that it creates a lot of noise during operation.
• Submersible for pumping water from a well. It is also used for wells deeper than 10 m. The main characteristic of the pump is the height where it can drive the water flow. It is difficult to install, maintain and even dismantle it, without professional help it is impossible to cope here.
• Drainage. It is mainly used for pumping out a pond or swamp with a lot of debris. Most often it is used when freeing flooded premises or cesspools from water. The internal shredder prevents the hose from clogging, even with relatively hard organic particles.

Pump selection criteria

To make the right choice and buy the best pump for watering your garden, you need to focus on the following parameters:

• Power. It should be calculated based on the ratio of 3-6 liters of water per day per 1 m2 of garden. That is, for high-quality irrigation of plants on a land area of ​​300 m2, at least 1800 liters of water are needed. Of course, no one will water the garden for days, so the pump should have such a throughput in 1 hour. If we take into account that the minimum figure was used for the calculations, then the power of the device should be rounded up to 2 m3 / h, and preferably more.
• Aggression. Allows you to understand how far and high the pump can push the water. It is measured in meters. If the direction is horizontal, then the device can pump liquid at a distance of 10 times more.
• Water type. If the water contains debris (branches, leaves, sludge, etc.), an appropriate pump is needed that can handle the dirty liquid.
• The presence of auto shutdown. Experts recommend buying a fixture with this option, as it will save money on breakdowns in case of emergency operation without water.

The best pumps for watering the garden

This rating took into account the above selection features and collected the best pumps for watering a garden on the market. Here are presented both world-famous manufacturers and more affordable domestic products with high performance, sufficient reliability and decent quality indicators of components.

Hammer NAP 900A

This is a drainage pump focused on watering a large area. Its throughput capacity reaches 14 m3 / h, which is enough to maintain the proper water saturation of the earth by 1-1.5 hectares. The special design of the centrifugal device makes it possible to pump contaminated liquid from reservoirs or large reservoirs in a regular mode. At the same time, the lifting height is no more than 8.5 m, so it is not suitable for deep wells or areas with a strong difference in height.In general, the design is solid: a solid body, a tight fit of the elements, a minimum of noise during operation.

Characteristic	Meaning
Maximum productivity	14 m3 / h
Max. pressure	8.5 m
Water type	Can pump dirty water

Testimonial: “I used it to pump out groundwater from the garage caisson. He coped with his task perfectly, even dirty water was in his teeth. The productivity is enormous, it pumps a full hole of 3-5 m3 in 15-20 minutes. "

KARCHER BP 1 Barrel Set

A product from the well-known company Karcher presents barrel pumps for garden irrigation. It comes with a pre-installed input filter. Thus, large debris cannot get inside, which affects the long service life. Sold complete with 15 m PrimoFlex 1/2 ”hose, spray gun, 2 connectors. The single-phase compact design can be carried quickly and is also easy to assemble. Its distinctive feature is increased wear resistance and the ability to work under increased loads.

Characteristic	Meaning
Maximum productivity	3.8 m3 / h
Max. pressure	11 m
Water type	For pure water only

Feedback: “As a gardener, the pump suits me perfectly. Built a rainwater collection system and installed a 3m3 capacity. When there is water, I also replenish the reservoir. I water the garden with pre-accumulated water at an excellent speed - 5-6 buckets per minute at a pressure of 1.1 bar. "

Quattro Elementi Drenaggio 400 Fles

Barrel-submersible device for pumping clean water at a modest price. It is not intended for deep installation more than 2 m, but the maximum head is a decent 12 m. The pump is capable of pumping 2.4 m3 / h in 1 hour - a good value for a model with a 370 W motor. The filtration system of the device blocks the entry of particles over 3 mm, so it feels calm in containers with rare large debris. The barrel pump provides for a float control of the liquid level in the tank, which saves from an accident during "dry running".

Characteristic	Meaning
Maximum productivity	2.4 m3 / h
Max. pressure	12 m
Water type	For pure water only

Review: “A good pump without any obvious flaws. It copes with its functions and can really pump the declared volume of liquid. "

STAVR NPD 400SH

A submersible drainage pump of a budget segment from a Russian company with a sufficient capacity of 3 m3 / h will be a godsend for owners of small plots. The main purpose is to pump clean water, but a slightly contaminated liquid is also within his power. The set includes a hose for complete draining of the filled container. The model offers a float mechanism that stops the operation of the motor when the water level falls to dangerous levels. It is made in a plastic case of average quality, which does not corrode, but it cannot be called too strong.

Characteristic	Meaning
Maximum productivity	3 m3 / h
Max. pressure	10 m
Water type	For pure water only

Testimonial: “I use it for pouring water over large barrels. Swings fast. I give 4 points on a 5 point system because I came across a defective plastic faucet. "

ZUBR NPG M1 400

The submersible model with an average productivity of 7.5 m3 / h is suitable for watering gardens of 0.5-1 hectares. At the same time, the price is only slightly higher than 2,000 rubles. It can be seen that the unit is simple and does not have unnecessary additions, which affects the cost and weight of only 3 kg. It can be immersed to a depth of 7 m. An important advantage of the model is its unpretentiousness to the type of water, it works not only with clean, but also dirty liquid. The filter blocks the penetration of debris with a diameter of 35 mm and more. The device is suitable for watering, pumping waste water, flooded rooms, rates, etc.

Characteristic	Meaning
Maximum productivity	7.5 m3 / h
Max. pressure	5 m
Water type	Pumps even dirty water

Review: “It costs an order of magnitude cheaper than an analogue in a local store, but at the same time it successfully copes with its task. Noise from work is not audible at all. I use it to pump out muddy, dirty groundwater. "

Metabo P 3300 G

The surface pump is an effective assistant for solving problems with watering your home garden. It can pump ground water, a pool, or simply pump liquid from different containers. Its key advantage is a huge head, which allows you to use a hose 45 m long. The throughput is small, but it is ideal for leisurely watering of the garden. It is based on a cast iron and stainless steel body, which provide sufficient reliability and long-term operation of the pump.

Characteristic	Meaning
Maximum productivity	3.3 m3 / h
Max. pressure	45 m
Water type	For pure water only

Testimonial: “I put it in the country to increase the pressure in the summer water supply. For this purpose, I approached, in the normal mode raised the pressure to 3.5 atmospheres. Feels like there is even a margin. "

GARDENA 3500/4 Classic

A small, clean water garden pump capable of pumping 3600 l / h up to 41 m through a hose. The presence of a pair of outputs makes it possible to connect several sprinklers. He knows how to pump liquid from various tanks up to 7 m deep, and almost all tanks fit this description. Can be used to increase pressure in a centralized network. The pump is easy to maintain and does not require any special operating skills. The only necessary action is to drain the liquid before the start of the winter season, for which a corresponding hole is provided.

Characteristic	Meaning
Maximum productivity	3.6 m3 / h
Max. pressure	41 m
Water type	For pure water only

Review: “The value for money is completely satisfied. My needs were covered with interest, I recommend to increase the pressure of the centralized water supply ”.

Jilex Jumbo 70/50 P

Not the cheapest surface pump, but in terms of its technical equipment it surpasses most of the competitors. The extremely reliable and durable unit has almost continuous service for users for 5+ years. It can raise water to a height of 9 m, which is useful for a deep well or an area with uneven terrain. Suitable for use in combination with a 50 m hose at a flow rate of 4.2 m3 / h. The device can work properly even at a temperature of 1 ° C, that is, it can be used immediately before the start of the cold season.

Characteristic	Meaning
Maximum productivity	4.2 m3 / h
Max. pressure	50 m
Water type	For pure water only

Feedback: “This pump has been working for me for more than 5 years without any complaints. Absolutely no problem. Remarkably pumps water from a river and a shallow well. "

VORTEX MON 370

Self-priming device for pumping clean liquid from any source at a distance of up to 30 m. The device is easy to install, operate and maintain, no special skills are required. It is distinguished from competitors by its ability to pump 45 l / min - this is the optimal value for watering a personal plot or providing water in a house. And all this at a modest consumption of 370 watts. The model is popularly known for its increased resistance to physical damage and adverse environmental conditions.

Characteristic	Meaning
Maximum productivity	2.76 m3 / h
Max. pressure	30 m
Water type	For pure water only

Review: “I put it in a well. It works well for watering and supplying water to the house. I realized everything through an additional divorce. Does not need regular maintenance, but it is advisable to install a non-return valve. "

Technopribor Rucheyok 1

The vibrating pump has already proven its reliability and efficiency. The model gained popularity due to its low price, it is the most affordable on the Russian market. The ability, with a compact size, to pump liquid up to 60 m, made this model ideal for watering a garden from a barrel, pond or well. The low price negatively affected productivity - only 1.05 m3 / h, which reduces the scope of its use. Also, it is intended only for working with clean water, so it is better not to lower it to the bottom.

Characteristic	Meaning
Maximum productivity	1.05 m3 / h
Max. pressure	60 m
Water type	For pure water only

Testimonial: “I put it in a well 25 m deep - it works great. Suitable for both watering and water supply in the house. True, there would still be more pressure, but an excellent device for its price. "

This is a detailed guide to the selection of a pump for watering a garden, which will help not only with advice, but also with deed.Having dealt with the features of the choice and the differences between devices, you can move on to specific models, which can now be called the best in the domestic market in terms of price and quality.